NS3000/iX Error Messages Reference Manual (36923-90041)

142 Chapter14

VALERR and VALWARN Messages

ACTION: This is not a problem if one of the LAP-B links conﬁgured for

this path is not activated. However, if a LAP-B link is brought up while

another such link is active at that physical path, an error will result

during link startup.

MESSAGE: X.25 INACTIVITY TIMER IS LESS THAN OR EQUAL TO

TCP CONNECTION ASSURANCE TIMER.

1102 CAUSE: The X.25 timer is set too low.

ACTION: Hewlett-Packard recommends that the X.25 Inactivity timer

be conﬁgured with a value greater than that of the TCP Connection

Assurance timer to avoid unnecessary closing and opening of the X.25

virtual circuit. For optimum performance, conﬁgure the X.25 Inactivity

timer (or the TCP Connection Assurance timer) so that the X.25 timer

has a greater value than the TCP timer.

MESSAGE: SVCPATH HAS NO X.25 ADDRESS—THIS IS VALID ONLY

FOR DDN.

1103 CAUSE: At least one SVCPATH entry does not have an X.25 address key

conﬁgured. This conﬁguration will work only if the link is connected to

a DDN.

ACTION: If the link is not connected to a DDN, make sure all SVCPATH

entries have an address key conﬁgured under the path

NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH.