NS3000/iX Error Messages Reference Manual (36923-90041)

140 Chapter14
VALERR and VALWARN Messages
MESSAGE: PVC NUMBER pvc IS DEFINED MORE THAN ONCE.
324 CAUSE: A PVC number is defined more than once under the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
ACTION: Make sure all PVC numbers are unique in a given PVC
configuration path.
MESSAGE: X.25 ADDRESS address is defined more than once.
325 CAUSE: An X.25 address is defined more than once under the
NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH path.
ACTION: Make sure all X.25 addresses are unique in a given SVC
configuration path.
MESSAGE: MORE THAN 1024 SVCPATHS CONFIGURED.
350 CAUSE: The number of SVC entries under the
NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH path exceeds the
maximum of 1024 allowed.
ACTION: Delete the excess SVC entries.
MESSAGE: MORE THAN 128 PVCPATHS CONFIGURED.
351 CAUSE: The number of PVC entries under the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path exceeds the
maximum of 128 allowed.
ACTION: Delete the excess PVC entries.
MESSAGE: COULD NOT BUILD PATH REPORT FOR CONFIGURATION
FILE.
900 CAUSE: An internal error occurred while building the local node's path
report to place in the configuration file.
ACTION: RESTORE a backup copy of NMCONFIG.PUB.SYS from tape and
try to validate the Network Transport again. If this fails, the
configuration file is corrupt. See Appendix A, “Submitting an SR,” of
this manual.
MESSAGE: COULD NOT ADD PATH REPORT TO CONFIGURATION
FILE.
901 CAUSE: An internal error occurred while adding the local node's path
report to the configuration file.
ACTION: RESTORE a backup copy of NMCONFIG.PUB.SYS from tape and
try to validate the Network Transport again. If this fails, the
configuration file is corrupt. See Appendix A, “Submitting an SR,” of
this manual.