NS3000/iX Error Messages Reference Manual (36923-90041)

14 Chapter1
CIERR Error Messages
MESSAGE: TOO MANY PARAMTERS IN TRACE OPTION.
5017 CAUSE: More than the five defined parameters were specified in a
DSLINE TRACE option.
ACTION: Correct the syntax and reissue the command.
MESSAGE: EXPECTED OR ‘.
5018 CAUSE: A string that begins with a quotation mark as a delimiter () or
(‘) does not end with a closing quotation mark () or (‘). You must use the
same delimiter for starting and ending the string.
ACTION: Correct the syntax and reissue the command.
MESSAGE: EXPECTED ; OR RETURN.
5019 CAUSE: An unexpected character was found after a command option.
ACTION: Correct the syntax and reissue the command.
MESSAGE: QUIET OVERRIDES PREVIOUS QUIET OPTION.
5020 CAUSE: Two or more QUIET options were specified.
ACTION: None.
MESSAGE: PROMPT OVERRIDES PREVIOUS PROMPT OPTION.
5021 CAUSE: Two or more PROMPT options were specified. The prompt
string from the last PROMPT is used.
ACTION: None (unless you do not want the last prompt; then correct
and reissue the command).
MESSAGE: LOGON OVERRIDES PREVIOUS LOGON OPTION.
5022 CAUSE: Two or more LOGON options were specified. The logon from
the last LOGON will be used.
ACTION: None (unless you do not want the last logon; then correct and
reissue the command).
MESSAGE: COMP OVERRIDES PREVIOUS COMP OR NOCOMP
OPTION.
5023 CAUSE: Two or more COMP and/or NOCOMP options were specified.
The COMP option will take effect.
ACTION: None (unless you do not want the COMP option; then correct
and reissue the command).
MESSAGE: NOCOMP OVERRIDES PREVIOUS COMP OR NOCOMP
OPTION.
5024 CAUSE: Two or more COMP and/or NOCOMP options were specified.
The NOCOMP option will take effect.
ACTION: None (unless you do not want the NOCOMP option; then
correct and reissue the command).