NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 14 139
VALERR and VALWARN Messages
MESSAGE: FIVE LOGGING CLASSES REQUIRED FOR
SUBSYSTEM 40.
114 CAUSE: All required logging classes are not configured for
subsystem 40. Six logging classes configured: CLAS0000, CLAS0001,
CLAS0002, CLAS0003, CLAS0004, CLAS0005.
ACTION: Use NMMGR to configure all classes under the path
LOGGING.SUB0040. Validate the network transport configuration
again.
MESSAGE: LINK TYPE FOR SNA NI MUST BE SNA.
115 CAUSE: A link of type SNA must be used when configuring an NI for
NS over SNA.
ACTION: Use NMMGR to configure a link of type SNA. Validate
Transport again.
MESSAGE: FACILITY SET setname DOES NOT EXIST.
300 CAUSE: In the SVCPATH configuration an X.25 address key is mapped
to an undefined facility set.
ACTION: Modify the X.25 address key so that it is mapped to an
existing facility set. Or, create a new facility set with the name to which
the X.25 address key is mapped.
MESSAGE: MUST DEFINE AT LEAST ONE X.25 ADDRESS KEY IN
SVCPATH OR PVCPATH.
313 CAUSE: At least one X.25 address key must be configured under either
the NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH or the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
ACTION: Use NMMGR to configure an address key under either the
NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH or the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
MESSAGE: MORE THAN 1024 X.25 ADDRESS KEYS CONFIGURED
(SVC + PVC).
322 CAUSE: More than the allowed number of address keys were defined.
The maximum number of combined SVC and PVC address keys allowed
is 1024.
ACTION: Use NMMGR to delete excess address key paths.
MESSAGE: X.25 ADDRESS KEY key IS DEFINED MORE THAN ONCE.
323 CAUSE: An X.25 address key was defined more than once under either
the NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH or the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
ACTION: Make sure an X.25 address key is configured only once. Delete
all but one of any given X.25 address key.