NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 14 135
VALERR and VALWARN Messages
MESSAGE: LINKTYPE MUST BE LAN802.3 IN LINK.
37 CAUSE: The NI type is LAN802.3, but the link configured corresponds
to a non-LAN link in Link Configuration.
ACTION: Configure a LAN802.3 type link on the NI Link Screen
(NETXPORT.NI.NIname.LINK).
MESSAGE: ONLY 1 WILD CARD ADDRESS MAPPING ALLOWED FOR
EACH ROUTER NI.
39 CAUSE: There are two or more Router Mapping Screens with the wild
card IP address “@” configured for the same router NI.
ACTION: Consult the discussion on the use of the wild card address on
the Router Mapping Screen in the NS 3000/iX NMMGR Screens
Reference Manual.
MESSAGE: WILD CARD ADDRESS REQUIRES THAT EXACTLY 2
ROUTER MAPPINGS BE CONFIGURED.
40 CAUSE: The wild card IP address was used in the specified Router
Mapping Screen and a total of 2 router mapping entries are not
configured for this router NI.
ACTION: Consult the discussion on the use of the wild card address on
the Router Mapping Screen in the NS 3000/iX NMMGR Screens
Reference Manual.
MESSAGE: WILD CARD ADDRESS ALLOWED ONLY WHEN SINGLE
NI LINK CONFIGURED.
41 CAUSE: A wild card IP address mapping is configured for this router
network, but more than one link is configured for this network under
the NETXPORT.NI.NIname.LINK screen.
ACTION: Use the NMMGR utility to change the configuration file so
that only one link is configured for this screen; or, do not use the wild
card for the IP address mapping. Validate the configuration file again.
MESSAGE: SUBSYSTEM 3 LOGGING NOT CONFIGURED.
42 CAUSE: The LOGGING.SUB0003 record does not exist in the
configuration file.
ACTION: Use the NMMGR utility to add the LOGGING.SUB0003 record
to the configuration file so that logging for Network Transport will be
configured. Be sure to add logging classes 1 through 6 to the
LOGGING.SUB0003 level. Validate the Network Transport again.
MESSAGE: NO LOGGING CLASSES CONFIGURED FOR
SUBSYSTEM 3.
43 CAUSE: There are no configuration file records beneath the
LOGGING.SUB0003 path in the configuration file.