NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 14 131
VALERR and VALWARN Messages
14 VALERR and VALWARN Messages
VALERR messages are returned to $STDLIST as a result of using the
configuration validation screen of NMMGR, or following the
NETCONTROL START and UPDATE commands. See Using the Node
Management Services (NMS) Utilities manual for information on using
this screen.
MESSAGE: NO DATA FOUND IN PATH RECORD.
1 CAUSE: No data has been entered for the specified path.
ACTION: Check for correct spelling of configuration path; enter data for
the path, if necessary.
MESSAGE: INCORRECT DATA LENGTH, LENGTH = n, EXPECTED = m
2 CAUSE: Name entered in configuration screen is too long.
ACTION: Rename, using no more than the expected number of
characters.
MESSAGE: NO CORRESPONDING LINK CONFIGURED.
3 CAUSE: Link name specified in link configuration screen
(LINK.linkname) differs from name in NETXPORT configuration screen.
ACTION: Make sure that link name specified in link configuration
screen (LINK.linkname) is the same as that specified in NETXPORT
screen.
MESSAGE: EXPECTED NO DATA IN RECORD, FOUND n BYTES.
4 CAUSE: Displayed path should contain no data.
ACTION: Contact your Hewlett-Packard representative for assistance.
MESSAGE: HOME NETWORK SPECIFIED NOT CONFIGURED.
5 CAUSE: Home network specified in the Global Transport Configuration
screen (path NETXPORT.GLOBAL) is not configured.
ACTION: Check name of IEEE 802.3 network interface as configured in
the Network Interface Configuration screen (path NETXPORT.NI).
Enter this name as Home Network Name in Global Transport
Configuration screen.
MESSAGE: CONFIGURATION PATH EXPECTED, NOT FOUND.
6 CAUSE: Displayed configuration path not found in configuration file.
ACTION: Contact your Hewlett-Packard representative for assistance.