NS3000/iX Error Messages Reference Manual (36923-90041)

126 Chapter12

NETXPORTERR Error Messages

ACTION: Using NMMGR, update the path and validate the DTS

subsystem.

MESSAGE: CANNOT FIND DTC CONFIGURED FOR DEVICE linkname.

4216 CAUSE: This error may be caused by one of the following reasons:

• The host has a non-existent DTC conﬁgured in the

NMCONFIG.PUB.SYS path LINK.linkname.

• The DTC conﬁgured in the NMCONFIG.PUB.SYS path

LINK.linkname is down or ﬂooded.

ACTION: Check the conﬁguration data and verify that it is correct.

Restart the DTC if necessary.

MESSAGE: MAXIMUM X.25 LINKS ALREADY STARTED, CANNOT

START DEVICE linkname.

4217 CAUSE: Too many X.25 links have been started on the host.

ACTION: Stop unused X.25 links or Network Interfaces.

MESSAGE: CANNOT OPEN NETWORK DIRECTORY FILE.

4218 CAUSE: NETCP was unable to open the ﬁle NSDIR.NET.SYS.

ACTION: Check to be sure that the ﬁles NSDIR.NET.SYS and

NSDIRK.NET.SYS exist. If they exist and they are not being accessed by

another process, then try recreating the ﬁles. Otherwise, see Appendix

A, “Submitting an SR,” of this manual.