NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 12 123
NETXPORTERR Error Messages
ACTION: Review the referenced NMERR elsewhere in this manual.
Confirm that there have been no validation errors with this
configuration file. If the error still occurs, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: TRANSPORT NOT YET DOWN.
4101 CAUSE: Detected upon issuing a NETCONTROL START command. The
prior NETCONTROL STOP command failed to completely terminate the
Network Transport.
ACTION: Perform the following steps:
1. Wait a few minutes, then retry the NETCONTROL START command. If
the problem persists, abort any remaining network users.
2. Submit an SR any time this problem occurs. See Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: CONFIGURATION FILE NOT OPENED.
4200 CAUSE: Opening the configuration file failed.
ACTION: Confirm that the configuration file NMCONFIG.PUB.SYS
exists and is valid. Retry the NETCONTROL command.
MESSAGE: INTERNAL BUFFER ERROR.
4201 CAUSE: Creating a network transport buffer area failed.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL CONFIGURATION FILE ERROR (NMERR= error
number).
4202 CAUSE: Accessing the configuration file returned the specified error.
ACTION: Review the description of the NMERR referenced elsewhere
in this manual. Confirm that there are no validation errors with the
configuration file. If the error still occurs, restore a backup copy of the
configuration file NMCONFIG.PUB.SYS.
MESSAGE: INTERNAL ERROR ON START.
4203 CAUSE: A serious internal error has been detected during the execution
of the NETCONTROL START command.
ACTION: SeeAppendix A, “Submitting an SR,” of this manual.
MESSAGE: linkname DEVICE STARTUP FAILED.
4204 CAUSE:
1. The configured device does not exist on the system.
2. The link connection is bad due to faulty hardware.
3. An internal error has occurred during device startup.