NS3000/iX Error Messages Reference Manual (36923-90041)

122 Chapter12
NETXPORTERR Error Messages
MESSAGE: THIS UPDATE IS NOT ALLOWABLE FOR THIS ENTITY.
4060 CAUSE: The entity associated with the NETCONTROL UPDATE command
may not be updated.
ACTION: Consult the NS 3000/iX Operations and Maintenance
Reference Manual for the correct syntax for the NETCONTROL command.
Once the syntax has been corrected, retry the command.
MESSAGE: CONFIGURATION FILE NOT VALID.
4061 CAUSE: Validation errors occurred on a NETCONTROL START or UPDATE
commands.
ACTION: Correct the invalid parameters in your configuration file and
try again.
MESSAGE: UNABLE TO LOCK CONFIGURATION FILE. (NMERR=
error number).
4062 CAUSE: Unable to lock the configuration file for execution of a
NETCONTROL START or UPDATE.
ACTION: Wait and try again; if problem persists, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: PROTOCOL START FAILED.
4063 CAUSE: During a NETCONTROL START one or more of the NI specific
protocols failed to start.
ACTION: Stop the network. Check the configuration of the effected
protocols to be sure that they are correct. Then restart the network. If
the error persists, then see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: GENERAL PROTOCOL STARTUP FAILED.
4064 CAUSE: During a NETCONTROL START one or more of the general
protocols or common modules failed to start. This prevented startup of
any NI-specific protocols. Any further attempts to start networks will
also fail, unless networking is first stopped.
ACTION: Do a netcontrol stop. Check the configuration of the TCP and
IP modules to be sure that they are correct. Then try restarting the
network. If the error persists, see Appendix A, “Submitting an SR,” of
this manual.
MESSAGE: VERSION ERROR: INTERNAL ERROR (NMERR= error
number).
4100 CAUSE: An internal error occurred while the network transport was
checking its module versions.