NS3000/iX Error Messages Reference Manual (36923-90041)

118 Chapter12
NETXPORTERR Error Messages
MESSAGE: TRACE OPEN ERROR.
4021 CAUSE: Usually, you are trying to open a trace on an already opened
trace file.
ACTION: Ensure that the trace file exists and is open. If it exists and is
not open, then see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: BAD DIAG VALUE, EXPECTED SET(0–31) OR RST(0–31).
4023 CAUSE: Invalid DIAG value.
ACTION: The DIAG keyword command is not for customer use.
Contact your Hewlett-Packard representative.
MESSAGE: NET NOT ALLOWED WITH PROT.
4025 CAUSE: The two entities (NET and PROT) cannot be used together.
ACTION: Pick appropriate entity and reissue command.
MESSAGE: EXPECTED VERSION KEYWORD MOD.
4026 CAUSE: User typed an illegal command.
ACTION: Type word MOD after VERSION=.
MESSAGE: FOPEN FAILED ON NETMSG.NET.SYS.
4028 CAUSE: Usually appears with an MPE XL command.
ACTION: Fix the MPE XL error. Ensure that the NETMSG file exists; if
it does, then see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: MESSAGE CATALOG ERROR ON NETMSG.NET.SYS.
4029 CAUSE: Usually appears with an MPE XL command.
ACTION: Fix the MPE XL error. Ensure that the NETMSG file exists; if
it does, then see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: GATE &NET FUNCTIONS ENTERED, ONLY ONE
ALLOWED.
4030 CAUSE: The GATE and NET keywords have been specified on the same
NETCONTROL command line.
ACTION: Reissue the NETCONTROL command using only one of the
keywords.
MESSAGE: TRACEON AND TRACEOFF NOT ALLOWED ON SAME
LINE.
4031 CAUSE: The TRACEON and TRACEOFF keywords have been specified on
the same NETCONTROL command line.
ACTION: Reissue the NETCONTROL command using only one of the
keywords.