NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 12 117
NETXPORTERR Error Messages
MESSAGE: BOTH START AND STOP ISSUED.
4009 CAUSE: Both parameters not allowed in a single NETCONTROL
command.
ACTION: Pick appropriate command. Correct and retry.
MESSAGE: INVALID TRACE TYPE. EXPECTED COMBINATION OF
D,H,M,B,N,S.
4011 CAUSE: Usually a typographical error. Recommended combination for
trace type is HMD.
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
MESSAGE: INVALID TRACE DESTINATION. EXPECTED DISC.
4012 CAUSE: Usually a typographical error. DEFAULT: Disk.
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
MESSAGE: INVALID FILE NAME.
4013 CAUSE: An invalid file name has been supplied with the NETCONTROL
TRACEON option. Usually a typographical error.
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
MESSAGE: INVALID RECORD SIZE, MUST BE >5 AND 1024.
4014 CAUSE: Trace file record size specified in command line parameter is
too large or too small.
ACTION: Correct with valid value; retry.
MESSAGE: INVALID FILE SIZE, MUST BE > THAN 32 AND 32000.
4015 CAUSE: Trace file size specified in command line parameter is too large
or too small.
ACTION: Correct with valid value; retry.
MESSAGE: CONTROL PROCESS NOT STARTED (NMERR= ! ).
4016 CAUSE: NMMON was unable to launch the Control Process, or user
issued a command when the transport was not active.
ACTION: Issue NETCONTROL START. Then retry command. If problem
persists, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: DATA DICTIONARY FULL, TRY AGAIN.
4017 CAUSE: Data dictionary full.
ACTION: Reissue the command after waiting a few minutes. If the
problem persists, then see Appendix A, “Submitting an SR,” of this
manual.