NS3000/iX Error Messages Reference Manual (36923-90041)

102 Chapter9
Remote Process Management Error Messages
MESSAGE: RPMDAD DEAD ERROR.
112 CAUSE: RPMDAD is terminating and exiting the session because the
session has been aborted or because all sons created by RPM have
terminated.
ACTION: Try again. A new RPMDAD and a new session are created at
the next RPMCREATE request.
MESSAGE: BAD RPMCONTROL STATE.
113 CAUSE: RPMCONTROL was unable to suspend the remote process. A
system process may have impeded the remote process, or the remote
process may be waiting for a system resource.
ACTION: Call RPMCONTROL again with the suspend option, or attempt
to use another method of synchronization such as NetIPC.
MESSAGE: SWITCH FAILURE.
114 CAUSE: RPM was unable to call a native mode procedure.
ACTION: See Appendix A, “Submitting an SR,” in this manual. The log
file (NMLGxxxx.PUB.SYS) may contain additional information.
MESSAGE: ADOPT FAILURE.
115 CAUSE: RPMDAD was unable to enter the remote session because the
remote session was being aborted.
ACTION: Try again. Make sure the session is not aborted before the
RPM son is created. The log file (NMLGxxxx.PUB.SYS) may contain
additional information.