NetIPC 3000/XL Programmer's Reference Manual (5958-8600)

190 AppendixC
Error Messages
NetIPC Errors
16 MESSAGE: OUT OF PATH DESCRIPTORS OR PATH DESCRIPTOR
EXTENSIONS.
CAUSE: Transport’s Path Cache or Path Descriptor table is full.
ACTION: Contact your operator to see if the table can be expanded.
18 MESSAGE: FORMAT OF THE opt RECORD IS INCORRECT.
CAUSE: NetIPC was unable to parse the specified
opt record.
ACTION: Check your INITOPT and ADDOPT calls.
19 MESSAGE: ERROR DETECTED WITH MAXIMUM MESSAGE SIZE
OPTION.
CAUSE: Maximum message size option in the
opt record had an error
associated with it (e.g., too many bytes specified, invalid message size
value).
ACTION: Check the values being placed in the
opt record.
20 MESSAGE: ERROR WITH DATA OFFSET OPTION.
CAUSE: Data offset option in the
opt record had an error associated
with it (e.g., too many bytes specified).
ACTION: Check the values being placed in the opt record.
21 MESSAGE: DUPLICATE opt RECORD OPTION SPECIFIED.
CAUSE: The same
opt record option was specified twice.
ACTION: Remove the redundant call.
24 MESSAGE: ERROR DETECTED IN MAXIMUM CONNECTION
REQUESTS QUEUED OPTION.
CAUSE: Maximum connection requests queued option in the
opt record
had an error associated with it (e.g., too many bytes specified, bad
value).
ACTION: Check the values being placed in the
opt record.
25 MESSAGE: SOCKETS NOT INITIALIZED; NO GLOBAL DATA
SEGMENT.
CAUSE: Error occurred attempting to initialize NetIPC, or Network
Management is still initializing.
ACTION: See “Submitting an SR” at the end of this appendix.
26 MESSAGE: UNABLE TO ALLOCATE A DATA SEGMENT.
CAUSE: The attempt to create a data segment failed because the DST
table was full or there was not enough virtual memory.
ACTION: Contact your operator to see if these tables can be expanded.