NetIPC 3000/XL Programmer's Reference Manual (5958-8600)
Table Of Contents
- 1 NetIPC Fundamentals
- 2 Cross-System NetIPC
- 3 NetIPC Intrinsics
- 4 NetIPC Examples
- A IPC Interpreter (IPCINT)
- B Cause and Diagnostic Codes
- C ErrorMessages
- D Migration From PTOP to NetIPC and RPM
- E C Program Language Considerations
172 AppendixA
IPC Interpreter (IPCINT)
Using IPCINT
Using IPCINT
To use IPCINT you must have an NS X.25 link up and running on a
local HP 3000 node and on a remote node. In order to exercise the
intrinsics between nodes, the remote node must be running either
IPCINT or an X.25 direct access to level 3 server program.
You must have NA or NM capability to run IPCINT. To use IPCINT you
enter RUN IPCINT.NET.SYS at the MPE XL prompt. At the IPCINT
prompt (>) you can enter a NetIPC intrinsic abbreviation or EX to exit.
You will be prompted for parameters required for the intrinsic you
specified. The intrinsic is executed by IPCINT and any output
parameters or errors returned are displayed. IPCINT creates a log file
called IPCLOG to contain the actions of each intrinsic executed.