NetIPC 3000/XL Programmer's Reference Manual (5958-8600)

16
• Appendix A , “IPC Interpreter (IPCINT),” describes how to use the
IPCINT software utility which provides an interactive interface to
the NetIPC intrinsics used for programmatic access to X.25 level 3.
• Appendix B , “Cause and Diagnostic Codes,” lists the possible cause
and diagnostic codes generated by NS X.25 packets.
• Appendix C , “Error Messages,” includes a list of SOCKERRs and
the corresponding protocol module errors returned in the
IPCCHECK intrinsic, and provides a table of NetIPC errors
(SOCKERRs) returned in the result parameter of the NetIPC
intrinsics.
• Appendix D , “Migration From PTOP to NetIPC and RPM,” explains
how to translate programs written in the Program-to-Program
communication service to NetIPC and RPM.
• Appendix E , “C Program Language Considerations,” describes
program language differences that affect how NetIPC intrinsics are
used in programs written in C programming language.
Related
Publications
The following publications contain additional information that can
assist you in using NetIPC.
NS 3000/XL • Using NS 3000/XL Network Services Manual
• NS 3000/XL Error Messages Reference Manual
• NS 3000/XL Configuration, Planning and Design Guide
• NS 3000/XL NMMGR Screens Reference Manual
• NS Cross-System NFT Reference Manual
• NS Cross-System Network Manager Reference Manual
X.25 Networking • X.25 XL System Access Configuration Guide
• Using the OpenView DTC Manager
MPE XL • MPE XL Commands Reference Manual
• MPE XL Intrinsics Reference Manual
• HP PASCAL Reference Manual
• HP COBOL II/XL Reference Manual
• FORTRAN 77/XL Reference Manual Supplement