NetBase for MPE Reference Guide

Using CONFIG

3-3

Configuring NetBase

Configuring NetBase consists of two parts, configuring the operational parameters and defining the

network nodes for NetBase. The configuration subsystem can only be entered through NBCTRL.

Configuration changes may require the creation of files that must reside in the NETBASE account.

Access to CONFIG is denied if the user is not logged into the NETBASE account or does not have SM

capability. Use the following steps to configure NetBase.

To configure the operational parameters:

1. Run NBCTRL by typing:

: RUN NBCTRL.PUB.NETBASE

∗> CONFIG

2. You may review each of the configuration parameters, or you may use the QUICK option to

highlight the essential parameters. As NetBase takes you through to specific parameters, you

can press Enter to keep the displayed values, or you can enter a new value.

C> MODIFY QUICK