NetBase for MPE Reference Guide

Appendix B
B-30
Shell Detected Errors
The following NetBase errors are detected by the shell.
ERR# Error Message Explanation/Action
8002
SHADOWING INVALID WITH
SPECIFIED HPFOPEN OPTIONS
Shadowing is invalid when used in
conjunction with HPFOPEN options 18, 21
(mapped files), 45, 50 or 52.
8003
REMOTE ACCESS INVALID WITH
SPECIFIED HPFOPEN OPTIONS
Remote access is invalid when used in
conjunction with HPFOPEN options 18, 21
(mapped files), 45, 50, 52 or 54.
8004
CANNOT OPEN LOCAL FILE FOR
REMOTE FILE NUMBER
NetBase internal error. If this error occurs
contact Quest Software.
8005
NATIVE MODE AUTO RPM NOT
ENABLED
AutoRPM is not yet enabled for the native
mode shell.
8006
SHADOWING INVALID WITH
FILE DISPOSITION SET
A file disposition of DEL, TEMP, SAVE or
SPSAVE has been specified for a file defined
for shadowing. These options are not valid
for shadowed files.
8009
DBCONTROL INVALID MODE,
LOCAL WHEN ASKED NOT SET
DBCONTROL mode to change to local access
used without dbcontrol mode 701 to allow
this.
8010
FUPDATE CALLED AFTER
FREADC, INVALID WITH THIS
OS
FUPDATE called after FREADC on a shadowed
file not supported before 4.0.
8011
CANNOT RENAME THE SHADOW
COPY OF A FILE
FRENAME called on the shadow copy of a file.
8012
CANNOT COPY A KSAMXL FILE
WITH THIS OS
Cannot create a new, remote KSAMXL file,
the operating system must be 4.0 or greater.
8013
CANNOT LOAD AIFKSMREAD FOR
COPY OF KSAMXL FILE
Cannot create a new, remote KSAMXL file.
The load of the AIFKSMREAD failed.
8014
CANNOT CREATE KSAM FILE,
NOT SUPPORTED BY SERVER
Server version on remote node does not
support creation of KSAMXL files.
Continued