NetBase for MPE Reference Guide

Appendix B
B-12
ERR# Error Message Explanation/Action
1010
INVALID OVERRIDE FLAGS
SPECIFIED BY JCW
Flags are set in the NBDISABLE JCW that
are not used by NetBase. Check the JCW
for invalid values.
1011
NO SERVERS AVAILABLE ON
REMOTE NODE
The number of users accessing files or
databases on the remote node exceeds the
maximum. The servers may be increased
by modifying the NFA - Maximum Remote
Users configuration parameter on the
remote node.
1012
NETBASE ACCESS DENIED BY
REMOTE NODE
Access to the local node by remote users
has been stopped using NetBase control.
1013
INVALID OVERRIDE FLAGS
SPECIFIED IN DIRECTORY
NetBase internal error. If this error occurs
contact Quest Software.
1014
NO RESPONSE FROM NETWORK
CONTROL PROCESS
See the console for error information. The
remote system may have gone down. Note:
an unusually high system load may cause
this problem.
1015
INVALID BYTE COUNT FOR NFA,
READ OR WRITE
The number of bytes to be written or read
exceeds 28,672.
1016
NO RESPONSE FROM REMOTE
SERVER PROCESS
See the console for error information. The
remote system may have gone down. Note:
an unusually high system load may cause
this problem.
1018
NETWORK TRANSPORT NOT
ACTIVE; MUST BE STARTED WITH
:NETCONTROL
Network transport must be active for
NetBase to run. Start the transport with the
:NETCONTROL command and restart
NetBase.
1019
REMOTE ACCESS NOT SUPPORTED
WITH SPECIFIED ACCESS
OPTIONS
A user process is attempting to open a file
with the nowait I/O access option.
1023
UNABLE TO OBTAIN FILE
INFORMATION DURING OPEN
NetBase internal error. If this error occurs
contact Quest Software.
1025
FILE CANNOT BE SHADOWED
Shadowing is invalid for non-disc files,
files opened for mapped access, and POSIX
files.