NetBase for MPE Reference Guide

Installation/Update Procedures for NetBase
A-3
Installation Steps
Once you have read the “Before Installing NetBase” section, take steps 1 through 4 to install
NetBase. Notice that the “Before Starting” section in Step 1 describes two system scenarios with
actions to take.
Step 1. Restore NETACCT job and STREAM NETACCT
To create NetBase's environment and install/update the software, you will restore a job into
PUB.SYS. This job is then streamed to create/update the NetBase account and restore the required
files.
Before Starting
Before doing Step 1, determine if any of the following scenarios describes your system, and if so,
take the action for that scenario.
• If you use VESOFT's STREAMX utility, do one of the following:
- Disable STREAMX and use the MPE STREAM command
- Modify the installation job and change each STREAM command to STREAMX
• If you use SECURITY/3000, enter this command prior to streaming the installation job:
:NEWACCT NETBASE,MGR;PASS=QUEST
• If you have a lockword on QUERY.PUB.SYS, remove it prior to streaming NETACCT.
To do Step 1:
_____ 1.1. Sign on to MANAGER.SYS and restore the job stream file:
Note. Characters in << >> marks are comments and are not entered or
displayed. User input is underlined and bold.
:HELLO MANAGER.SYS,PUB
:RESTORE ;NETACCT.JOB.@;LOCAL
<<reply to the tape request>>