NetBase for MPE Reference Guide

Chapter 4
4-26
LISTD
The LISTD command is used to display the devices that are defined in the NetBase directory. The
display shows the mapping of spool files across the network. For example, the display header
appears as follows:
T U
E S
---LOCAL--- ------REMOTE------ -----ALTERNATE----- -----COPY-----M E
ldev/class ldev/class node ldev/class node ldev/class P R
The following table provides descriptions of the items in the display header.
Header Item Description
LOCAL
ldev/class
The ldev number or class name of the device as it is referenced by local
user processes.
REMOTE
ldev/class node
The ldev number or class name of the actual device and the node on
which the actual device resides.
ALTERNATE
ldev/class node
The name and location of an alternate device where NetBase will route
the spool file if the REMOTE node is not available.
COPY
ldev/class
The device information for a local device to which a copy of the spool
file will be sent.
TEMP
If set to T, this flag indicates that the local copy of the spool file is
purged after transfer of the file to the remote node is complete.
Syntax
D> LISTD [deviceset]
Parameters
Parameter Description
deviceset
The logical device number or the device class of the record to
be listed. If the device set is omitted, all devices are listed.
Wildcards may be used.