NetBase for MPE Reference Guide

Chapter 3
3-30
SHADOW - Save Process Info on Post
This flag is used in conjunction with Post User Exits to pass process info from the originating
process to the user exit procedure. The originating node must also have turned on the Export
Process Info parameter. Do not enable this feature unless Post User Exits are being used. This
parameter takes effect when a post process is started.
Default = N
SHADOW - Abort Post on Errors
This parameter causes the posting process to terminate immediately if a sync error or an error
causing a discard has occurred. This allows corrective action to be taken without discarding a
transaction. If the error causing the abort is not corrected, Post will abort when it is restarted. This
parameter takes effect when a post process is started.
Default = N
SHADOW - Buffered Exporting
This parameter enables the buffering of shadowed transactions. This feature causes the export
process to wait a configured amount of time before transporting in an effort to share a single
network transaction across several shadow update transactions, significantly reducing Network and
CPU overhead.
Default = Y
SHADOW - Transfer mode only
This parameter enables Shadow Transfer Only Mode. This mode changes the behavior of EXPORT to
transfer in bulk only and never go into the ACTIVE state. This must be set to Y on both nodes in
order to enable this feature. This parameter is mainly useful for dial-up connections. This feature
requires that the Startup Access node parameter be set to W and the SHADOW - Direction node
parameter set to B. It takes effect when NetBase is started.
Default = N