NBSpool for MPE Reference Guide

Chapter 3

3-22

COPY Parameters (for all destinations)

Turn to the “MOVE Parameters” section in this chapter for information on the available

COPY

command parameters. All parameters are the same, with one exception for the

COPY

command.

The parameter is defined as follows:

Parameter Description

newpri

This parameter specifies the output priority that will be assigned to the

original spool file after successful completion of a copy. Must be between

and

RETRY

Specifies that during a

COPY

, if the destination node is unavailable, a

delay of five seconds should be followed by an attempt to reconnect.

RETRYDELAY

Specifies

RETRY

, as above, with a delay in seconds as specified, instead

of the default time of five seconds.

COPY Examples

In the following example, all spool files named

CATLIST

are duplicated onto node

MASTER

. Note

that this command will leave the original copy on the local computer.

:DSLINE MASTER;LOGON=NBSPOOL,OPERATOR.SYS

ENVIRONMENT 1: MASTER.QUEST.SOFTWARE

:RUN NBSPOOL.PUB.NETBASE

QUEST Software, Inc.

O> COPY CATLIST TO *MASTER

1 Spool file Qualifies

Connecting with MASTER...

DFID FILENAME JOB USER NAME SECTORS STATUS

------------------------------------------------------------------

#O580 CATLIST #S62 MGR.NETBASE 84 Copied as #O54