NBSpool for MPE Reference Guide

Chapter 7
7-20
Error Message Explanation/Action
UNEXPECTED ADDITIONAL PARAMETERS
You specified unnecessary parameters which
cannot be executed.
*2
UNEXPECTED PARAMETERS AFTER NODE
NAME
The parameters you specified after the node name
are inappropriate for this command, or they must
precede the node name specification.
*2
UNEXPECTED RESPONSE FROM REMOTE:
! !
The remote computer is not behaving normally.
Ask you network operator to investigate.
*2
UNKNOWN COMMAND ENTERED
NBSpool does not recognize the command you
entered. Verify the spelling and syntax.
*2
UNKNOWN KEYWORD SPECIFIED
The keyword you specified does not exist (for this
command).
*2
UNKNOWN NODE NAME SPECIFIED
NBSpool does not recognize the node name you
entered. Verify and re-enter.
*2
UNKNOWN PRINTER TYPE SPECIFIED
The printer type you specified does not exist.
Turn to the “PRINT” section in Chapter 3 for
more information on printer definitions.
*2
UNKNOWN SORT KEY SPECIFIED
The sort option you specified does not exist.
*2
UNKNOWN SPECIFICATION ENTERED
The parameter you entered is invalid for the
command you are using. Re-enter your
parameter.
*2
UNSUPPORTED CARRIAGE CONTROL !
DETECTED
The file you selected contains a carriage control
character which NBSpool cannot handle.
*2
WAIT VALUE MUST BE BETWEEN 1 AND
600 SECONDS
The value you entered was not within the
acceptable range for the
WAIT
command.
*2
WARNING: BAD CHECKSUM ON ARCHIVE
HEADER
The archive file is corrupt.
WARNING: Disabling Tape Volume
recognition. Put tape online now.
NBSpool will now ignore tape volume labels.
Proceed with caution.
WARNING: Help catalog ! not found
You may need to restore it from tape. If you no
longer have the tape, write down the exact
message, and call Quest Technical Support who
will transfer it to you.