NBSpool for MPE Reference Guide

Troubleshooting NBSpool
7-13
Error Message Explanation/Action
NFS/iX IS NOT INSTALLED ON THIS
SYSTEM
Without NFS/iX on your system, this command
will not work. Contact your Quest Sales
Representative for more information.
*2
NO CLOSING QUOTE FOUND FOR STRING
You began a string specification with a quotation
mark, but you omitted the closing one. Correct,
and execute.
*2
NO FILES FOUND IN SPECIFIED FILE SET
The fileset you specified does not contain any
files.
*2
NO PREVIOUS SUBSET EXISTS
You must specify a subset.
*2
NO SPOOL FILE HAS BEEN OPENED WITH
THE TEXT COMMAND
You must
TEXT
the file before performing this
command.
*2
No spool file headers found before end of
tape.
This tape does not contain spool files.
No tape errors detected. Unable to continue
processing.
Although the tape does not contain typical errors,
NBSpool cannot process your request concerning
this tape. Perhaps the tape is formatted, but
empty.
NO to-node SPECIFIED
You did not enter
;TO= node
as part of the
command as NBSpool expected.
*2
NODE IS NOT CONFIGURED
The node you specified has not been configured.
NBSpool cannot access it.
*2
NODE NAME > 8 CHARACTERS
The node you specified exceeded
8
characters in
length. Verify and re-enter.
*2
NOT A FIXED ASCII FILE
You may not perform this command on a
variable length file.
NOT ENOUGH ROOM IN THE ARCHIVE FILE
You must expand the archive file in order to add
these files to it.
*2
NOT ENOUGH ROOM IN THE ARCHIVE FILE
DIRECTORY
You must expand the archive file directory in
order to add these files to it.
*2
. Turn to the
“ARCHIVE” section in Chapter 3 for more
information.