NBSpool for MPE Reference Guide

Chapter 7
7-4
Error Message Explanation/Action
#THE GATEWAY IS AT CAPACITY OR THE
GATEWAY SOFTWARE IS NOT RUNNING
Ask your network administrator to verify that the
Gateway software is running. If it is, its number
of connections may need to be increased.
*2
$BACK IS NOT SUPPORTED
You may not specify the MPE
BACK
command
within NBSpool.
*2
47UNABLE TO WRITE ON REMOTE
NBSpool cannot write a file to the remote. This
message appears from the remote in response to a
data block request, indicating a possible lack of
disk space on the remote.
*2
A DESTINATION PRINTER NAME IS
REQUIRED
You must specify a printer name for the
destination.
*2
ABORTED BY CONTROL-Y
You pressed
CTRL-Y
during the processing of the
command. The command was aborted.
BANNER ERROR: No BANNER data base
found
Stream
BANNERIN.JOB
to build a
BANNER
data
base.
BANNER NOT ADDED
The banner you specified was not added. Verify
your commands and retry.
BLOCK SIZE > 8192 BYTES
The block size you stated exceeded NBSpool’s
limit of 8192 bytes. Restate the block size.
CANNOT BUILD SPOOL FILE
NBSpool failed to build the spool file. Perhaps
your system is low on disk space. Contact your
system manager.
CANNOT CLOSE QUEUE FILE
NBSpool cannot close the network queue.
CANNOT CONTINUE COMMAND DUE TO
PREVIOUS ERROR
Due to a previous problem, NBSpool cannot
continue.
*2
Cannot create file, NBSPOOL user cannot
access directory
User
NBSPOOL
needs to be granted file creation
rights to the specified directory with
GRANT
utility.
CANNOT EXECUTE COMMAND: NETBASE
IS NOT RUNNING
The command you entered required NetBase
which is not running. Ask you system operator
why NetBase is not running.
*2