NBSpool for MPE Reference Guide

Chapter 3
3-100
TAPEDIR
The
TAPEDIR
command displays the directory of one or all tape files on a NBSpool created
STORE
tape. The format is the same as the
SHOW
command’s listing. If the tape is in
SPOOK
format, the
keyword
SPOOK
must be specified. The size of files in sectors will be replaced with the number of
records in the spool file, due to a lack of information needed to compute the size of the spool file.
The formal file designator for the tape file is
NSPOOL
.
TAPEDIR Syntax
O> TAPEDIR [{seq }] [;DEV={class}]
[{@ }] [ {ldev} ]
[{SPOOK}]
User Tip. This command may be abbreviated to
TAP
.
TAPEDIR Parameters
Parameter Description
seq
This parameter specifies which of the various tapes files will be listed.
Numbering is sequential, starting at
1
. If omitted, the default is
1
.
@
This parameter specifies that all tape files on the current volume set will be
listed. Applicable only if the
APPEND
parameter was used on this tape.
SPOOK
This parameter specifies the tape is in
SPOOK
format.
class
This parameter specifies the device class on which the tape or serial disk is
mounted.
ldev
This parameter specifies the logical device on which the tape or serial disk is
mounted.