MPE/iX System Utilities Reference Manual (32650-90882)

182 Chapter20
SAINT
Operation
Example
LOADSYSLIB nl.abuild00.official
MAP
This command generates a map of the boot images symbol table. It describes the location
of the major components of the boot image. In addition, a flag in the command's parameter
list turns on the display of symbolic information obtained from the library symbol tables
contained within the boot image.
Syntax
MAP [
filename [, radix [,sym]]]
Parameters
filename The name of the boot image file used to generate the map and symbol
table. Default is PME under construction.
radix The base in which to display numeric output.
SYM A keyword which allows the display of symbolic information from the boot
images tables.
Examples
MAP
MAP boot imagefile1,H,sym
Error Messages
The following pages list some of the more common error messages you may encounter, the
probable cause and a suggested action.
The Physical Destination address is too small, will overlay ISL
CAUSE The NL used to build this PME has the first-resident or initially resident
page at a virtual address that is less than expected. The destination
address is the address ISL will use to load the PME. If that destination
address is lower than the end of ISL, the PME will not be loaded by ISL.
ACTION Change the linker commands used to build the NL that is the source of the
PME. The linked commands that affect the location of the pages are the
limit option on the buildxl command and the cleanxl command.
The Physical Destination address is smaller than expected, MAY overlay ISL
CAUSE The NL used to build this PME has the first-resident or initially resident
page at a virtual address that is less than expected. The destination
address is the address that ISL uses to load the PME. If that destination
address is lower than the end of ISL, the PME is not loaded by ISL. The
destination address may or may not be lower than the end of ISL. The end
of ISL is dependent on: