MPE/iX System Utilities Reference Manual (32650-90882)

Chapter 6 101
DISCUTIL
Operation
**** BEFORE THE CURRENT SAVE COMMAND IS COMPLETE WILL CAUSE FILES ****
**** TO BE LOST!!! TYPE (Return) at "ENTER FILE SET TO BE SAVED:"****
**** to complete the SAVE properly. SEE HELP "SAVE". ****
**********************************************************************
ENTER FILE SET TO BE SAVED: MYFILE.JOHN.SMITH
TRAVERSE DIRECTORIES UNDER FILESET (Y/N)? n
ENTER THE LDEV: 3
ENTER THE MODIFICATION DATE(MM/DD/YYYY):05/25/1994
ENTER THE TAPE LDEV: 7
MYFILE .JOHN .SMITH - LDEV 3 - ADDR $0002CA0 - FOUND
MYFILE .JOHN .SMITH - LDEV 3 - ADDR $0002CA0 - SAVED
**********************************************************************
***************************** WARNING!!! *****************************
**** MANUALLY REWINDING THE TAPE DRIVE AND STARTING A NEW TAPESET ****
**** BEFORE THE CURRENT SAVE COMMAND IS COMPLETE WILL CAUSE FILES ****
**** TO BE LOST!!! TYPE (Return) at "ENTER FILE SET TO BE SAVED:"****
**** to complete the SAVE properly. SEE HELP "SAVE". ****
**********************************************************************
ENTER FILE SET TO BE SAVED:
SHOWDEV
The SHOWDEV command displays information about each device that is currently in the
system configuration. For each configured device, the device's
ldev, class, and physical
are displayed.
To invoke SHOWDEV enter:
discutil>SHOWDEV
The system responds with a display similar to the following:
1 DISC 2/4.0.0
3 DISC 2/4.0.2
7 TAPE 6/4.3.0
20 TERMINAL 2/4.1.0
21 DISC 6/4.0.0
25 DISC 2/8.0.0
TAPE
Use the TAPE command to display the ldev number of the current tape or to specify a new
current tape. If the ldev parameter is omitted, the current tape ldev is displayed. If the
ldev parameter is supplied, that ldev will become the new tape ldev . The ldev must have
been configured as a tape.