MPE/iX Shell and Utilities Reference Manual, Vol 2

rcsclean(1) MPE/iX Shell and Utilities rcsclean(1)
Message: Can’t unlink filename: system error
Cause: See syserror(3).
Action: See syserror(3).
Message: co failed: system error
Cause: See syserror(3).
Action: See syserror(3).
Message: No filename present for –F option.
Cause: You specified the –F option, but did not provide a file name as its argument.
Action: Provide the missing file name.
Message: No input file.
Cause: You failed to specify an input file on the command line.
Action: Provide the missing file name.
Message: no revisions present
Cause: You specified a file which has an associated
RCS file that does not contain any
revisions. This is probably because it was created with ’rcs -i’ and no revisions
have been checked in yet.
Action: rcsclean will not clean up such files.
Message: too many revision numbers
Cause: You specified more than one revision number on the command line.
Action: Specify only one revision number on the command line.
Message: Unknown option "–option"
Cause: You specified an option that is not valid for rcsclean.
Action: Check the DESCRIPTION section of this man page for a list of valid
rcsclean options.
Message: unlocking failed: system error
Cause: See syserror(3).
Action: See syserror(3).
For a list of error messages common to all
RCS utilities, see rcserror(3).
PORTABILITY
All UNIX systems.
The –F, –K, –O, –q, and –Y options are extensions to traditional implementations of
rcsclean.
MPE/iX NOTES
Due to the fact that the comma (,) is not a valid character in MPE/iX file names, the traditional
,v naming convention is not currently implemented. This means that you must have a sub-
directory named RCS under your current directory or RCS will not work properly.
1-468 Commands and Utilities