MPE/iX Shell and Utilities Reference Manual, Vol 2

rlog(1) MPE/iX Shell and Utilities rlog(1)
Message: Missing log entry
Cause: While parsing the RCS file, rlog could not find the log entry. The RCS file is
corrupt.
Action: Retrieve an earlier revision of the RCS file and build from there.
Message: Missing revision or branch number after -r
Cause: You specified the –r option without providing a revision or branch number as
its argument.
Action: Provide the missing revision or branch number.
Message: Missing state attributes after -s options
Cause: You specified the –s option without providing a state as its argument.
Action: Provide the missing state.
Message: No filename present for –F option.
Cause: You specified the –F option, but did not provide a file name as its argument.
Action: Provide the missing file name.
Message: No input file.
Cause: You failed to specify an input file on the command line.
Action: Provide the missing file name.
Message: option –t overrides –h
Cause: You specified both –t and –h. You specified both the –t option and the –h
option. These two options are mutually exclusive. The command behaves as
though only the –t option was specified.
Action: If you do not want the behaviour described under CAUSE, specify only one of
the two options.
Message: separator expected near rev
Cause: You used the –r option to specify a list of revisions, but the list did not follow
the expected syntax.
Action: Check the DESCRIPTION section for the proper syntax when providing a list of
revisions with the –r option.
Message: syntax error; expecting EOF
Cause: The
RCS file did not contain an end-of-file character as the last character in the
file.
Action: Edit the RCS file manually and save it. This inserts an end-of-file character at
the end of the file. Be sure to remove any whitespace characters that will imme-
diately precede the new end-of-file character before saving.
1-492 Commands and Utilities