MPE/iX Error Messages Manual Vol 3 (32650-90880)

76 Chapter2
Error Messages Viii C 2
HPIO Channel Manager
spontaneously, without a direct order to
destroy the transaction.
CAUSE Hardware error reported.
ACTION No action required.
219 MESSAGE A request message contains an illegal buffer
address class field.
CAUSE Software error reported.
ACTION No action required.
220 MESSAGE A request message specifies an illegal device
adapter address.
CAUSE Software error reported.
ACTION No action required.
221 MESSAGE The DEVICE ADAPTER is not ready to receive a
command.
CAUSE Defective device adapter card.
ACTION Run diagnostics on the device adapter card.
222 MESSAGE The DEVICE ADAPTER encountered a SUBCHANNEL
ERROR TRAP while processing an I/O
transaction.
CAUSE Defective device adapter card.
ACTION Run diagnostics on the device adapter card.
223 MESSAGE The DEVICE ADAPTER is not ready to accept an
RSC (resume subchannel) command. As a result,
the subchannel is assumed to be in a
permanently PAUSED condition.
CAUSE Defective device adapter card.
ACTION Run diagnostics on the device adapter card.
224 MESSAGE The channel hardware has set a SUBCHANNEL in
a not ready to start DMA state. This error
condition is indicative of a hung device
adapter card.
CAUSE Defective device adapter card.
ACTION Run diagnostics on the device adapter card.
225 MESSAGE The virtual quad chain contains an illegal
CLC (connect LOGCHANNEL) order.
CAUSE Software error reported.
ACTION No action required.
226 MESSAGE The virtual quad chain contains an ILLEGAL