MPE/iX Error Messages Manual Vol 3 (32650-90880)
74 Chapter2
Error Messages Viii C 2
HPIO Channel Manager
ACTION Increase the load field in the SYSGEN I/O configuration
file for the channel to 256.
186 MESSAGE The internal LOGCHANNEL TABLE has been
exhausted of free entries. A unique
LOGCHANNEL number is assigned to each active
I/O transaction on the channel hardware.
CAUSE Too many concurrent I/O requests were activated on the
channel.
ACTION Increase the load field in the SYSGEN I/O configuration
file for the channel to 256.
191 MESSAGE The interrupt completion list contained an
invalid list address. When a DMA operation is
completed, the channel hardware updates this
list before sending a completion interrupt.
CAUSE Interrupt completion list has been corrupted.
ACTION Take a system dump for analysis.
192 MESSAGE The partial residue completion list contained
an invalid list address. This list is updated
by the channel hardware to return residue
count information on
a DMA order completion.
CAUSE Residue completion list has been corrupted.
ACTION Take a system dump for analysis.
195 MESSAGE The CHANNEL ADAPTER MANAGER attempted a
diagnostic loopback test, but failed.
CAUSE Defective CIO channel adapter hardware.
ACTION Replace CIO channel adapter hardware.
196 MESSAGE The CHANNEL ADAPTER MANAGER attempted a
diagnostic hardware selftest, but failed.
CAUSE Defective CIO channel adapter hardware.
ACTION Replace CIO channel adapter hardware.
200 MESSAGE The event handling procedure detected an
invalid lock event option.
CAUSE Software error reported.
ACTION No action required.
206 MESSAGE The reply to a request message could not be
sent, because the descriptor field in the
request message header was illegal.
CAUSE Software error reported.