MPE/iX Error Messages Manual Vol 3 (32650-90880)
Chapter 1 47
Error Messages
Distributed Terminal Subsystems
NMCONFIX, status SSSSSSSS.
CAUSE The NMCONFIX.PUB.SYS does not exist, or a file system or hardware
problem exists.
ACTION Check that the NMCONFIX.PUB.SYS file exists. If it does not, restore it. If
the file exists, check for file system or hardware problems.
MESSAGE DCC WARNING P-L, (Startup) cannot copy record to NMCONFIG,
status SSSSSSSS.
CAUSE The NMCONFIG.PUB.SYS file does not exist, or a file system or hardware
problem exists.
ACTION If the file does not exist, create it. If the file exists, check for file system or
hardware problems.
MESSAGE DCC WARNING P-L, (Startup) cannot close NMCONFIG, status
SSSSSSSS.
CAUSE The NMCONFIG.PUB.SYS file does not exist, or a disk space, a file system,
or hardware problem exists.
ACTION Check that the NMCONFIG.PUB.SYS file exists. If it does not exist, restore
it. If the file exists, check for a disk space problem, a file system problem,
or a hardware problem.
MESSAGE DCC WARNING P-L, (Startup) cannot close NMCONFIX, status
SSSSSSSS.
CAUSE The NMCONFIX.PUB.SYS file does not exist, or a disk space, file system, or
hardware problem exists.
ACTION Check that the NMCONFIX.PUB.SYS exists. If it does not exist, restore it. If
the file exists, check for a file system problem or a hardware problem.
MESSAGE DCC ERROR P-L, Blank NODENAME.
CAUSE A host node name was not configured.
ACTION Configure a host node name.
MESSAGE DCC ERROR P-L, Configuration file not validated.
CAUSE Either modifications were made to the network management configuration
file and the file was not validated, or the file was validated but the errors
listed to the console were not corrected.
ACTION Either validate the network management configuration file, or correct the
errors listed to the console when the file was first validated. Then
revalidate the file. The host will be rebooted.