MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 43
Error Messages
Distributed Terminal Subsystems
CAUSE The same logical device (ldev) number is used more than
once.
ACTION Remove duplicate ldev number.
44 MESSAGE Path: NMMGRpath
The same LDEV #nnn is being used at
DTS.DTCPC.SELECT.linkname .CARD012.(DTSERR=44)
CAUSE The logical device (ldev) number is used more than once in
the CARD012 configuration.
ACTION Remove any duplicate references to the ldev number.
45 MESSAGE Path: NMMGRpath
The same LDEV #nnn is being used at
DTS.DTCPC.SELECT.linkname .CARD345.(DTSERR=45)
CAUSE The logical device (ldev) number is used more than once in
the CARD345 configuration.
ACTION Remove any duplicate references to the ldev number.
46 MESSAGE Path: NMMGRpath
The same node name is being used at linkname.
(DTSERR=46)
CAUSE The same node name is used more than once.
ACTION Remove the duplicate reference to the node name.
47 MESSAGE Path: NMMGRpath
Blank node name. (DTSERR=47)
CAUSE A host node name is not specified on the screen specified in
the path.
ACTION Enter a host node name on the screen specified in the
path.
DCC Error Messages
As system start-up nears completion, the Datacomm Configurator (DCC) creates the LINK
and DTS managers. If the procedure is successful, the following message will be displayed
on the console:
DCC STARTUP - OK!
If the procedure is not successful, the message above is replaced by one or more error
messages. When looking up an error message, note that the following strings of characters
are used to represent information that is inserted when the message is generated:
• P-L is replaced by a DCC procedure number and DCC location number; used for
detailed diagnostics by Hewlett-Packard support representative.
• SSSSSSSS is replaced by an eight-digit hexadecimal value; also used for detailed