MPE/iX Error Messages Manual Vol 3 (32650-90880)

310 Chapter7
TurboIMAGE/XL V iii C 5
Workstation Configuration
!(ulogerr 49)
50 MESSAGE Log process for logid !has experienced a
previous error with the log file, and
therefore cannot perform a changelog
(ulogerr50)
51 MESSAGE Changelog from log file !to !for logid !was
lost when the system went down (ulogmsg 51)
52 MESSAGE Changelog for logid !was lost when the system
went down (ulogmsg 52)
53 MESSAGE Power fail detected on ldev # !. Serial disc
recovery in progress. (ulogmsg 53)
54 MESSAGE User logging power failure recovery
COMPLETED. (ulogmsg 54)
Workstation Configuration
(TTUTIL)
The error messages listed occur while entering data for a terminal-type or printer-type file.
Messages are displayed in inverse video on the bottom line of the screen. If the error(s) are
related to a field (or fields) on the screen, the fields are highlighted in full bright, inverse
video. If more than one field contains an error, only the error message for the first
highlighted field is displayed.
MESSAGE Character already has other function.
CAUSE The character entered has been defined elsewhere to have a different
special meaning. Each character can have only one special function.
ACTION Choose a different character for this special function, or release this
character for use by selecting a different character for the other special
function.
MESSAGE Character value out of range.
CAUSE The character input was out of the range of characters allowed for that
function.
ACTION Input a character within the range.
MESSAGE File is damaged; checksum error.
CAUSE The file has been damaged so that the checksum is no longer valid. The
utility still reads the data from the file into the work area, and when
saving the data back to the file, a correct checksum is generated.
ACTION Press
Enter again to go to the form selected. Verify the data on the screen.