MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 7 277
TurboIMAGE/XL V iii C 5
Utility Error Messages
ACTION Disable AUTODEFER and enable ROLLBACK using DBUTIL.
MESSAGE BACKUP DATABASE AND LOG FILE DO NOT MATCH
CAUSE The logid of the log file and the logid in the database being recovered do
not match; i.e., the correct log file is not being used for recovery.
ACTION Make sure that the database is using the correct log file.
MESSAGE BAD DATA BASE REFERENCE
CAUSE Data base reference following the utility program :RUN command has a
syntax error.
ACTION Correct the error in session mode or press return to terminate the
program.
MESSAGE BAD MAINTENANCE WORD
CAUSE User invoking the utility is not the creator of the referenced database and
has not supplied the correct maintenance word.
ACTION Correct the error in session mode or press return to terminate the
program.
MESSAGE CANNOT ENABLE BREAK KEY
CAUSE Internal error.
ACTION Contact your system manager.
MESSAGE CANNOT OPEN DATABASE
CAUSE The database cannot be opened at this time. It may already be open in a
mode that does not allow concurrent access.
ACTION Try the DBUTIL command again later.
MESSAGE CANNOT PARSE LOG FILE NAME
CAUSE Internal error.
ACTION Contact your system manager.
MESSAGE CAN'T RECOVER DATA BASES IN STATISTICAL MODE
CAUSE The CONTROL STATS command was entered subsequent to a RECOVER
command.
ACTION Rerun DBRECOV without using statistical mode, or use statistical mode
without specifying databases or recovery.
MESSAGE CAN'T OPEN DATA BASE-
DBERROR message
CAUSE Database cannot be opened.
ACTION Check the DBERROR message to determine the problem.
MESSAGE CHECKSUM FAILURE ON LOG RECORD #
n -EOF ASSUMED
CAUSE May occur if the system failed and a startup recovery is not performed.
Also may occur if a statistical recovery is used against an open log file.