MPE/iX Error Messages Manual Vol 3 (32650-90880)

266 Chapter6
TurboIMAGE/XL V iii C 5
Library Procedure Error Messages
ACTION Notify system manager.
-206 MESSAGE Data base exceeds limits
CAUSE DBOPEN has detected that the remote TurboIMAGE/XL
database exceeds the local IMAGE limitations. Remote
database access cannot be completed. A TurboIMAGE/XL
database can only be accessed from a local node (which has
IMAGE) if and only if the remote database has not
exceeded the IMAGE/3000 data set and data item
limitations.
ACTION Access the remote TurboIMAGE/XL database from
another local node which also supports TurboIMAGE/XL.
-208 MESSAGE MPE error
nn returned by FLABELINFO for MPE XL
XM
CAUSE The MPE/iX file system error nn was returned by the
intrinsic FLABELINFO.
ACTION Notify HP Support Representative.
-209 MESSAGE Invalid mode for MPE XL XM DETACH
CAUSE An internal error has occurred.
ACTION Notify HP Support Representative.
-210 MESSAGE MPE error
nn on log file name
CAUSE MPE/iX file system error
nn was returned while trying to
obtain the user log file name.
ACTION Notify HP Support Representative.
-3
nn
MESSAGE Internal error returned
CAUSE Internal error
nn occurred while in an intrinsic.
ACTION Notify HP Support Representative.
-1000 MESSAGE Switch failure, INFO
nn , SUBSYS nn
CAUSE The switch to Native Mode failed. SUBSYS nn is the
subsystem that failed. INFO
nn is the error number
returned from that subsystem.
ACTION Notify HP Support Representative.
-1001 MESSAGE Switch to CM failed on CX'PCBXIMAGE
CAUSE Internal error. This error is returned when DBOPEN calls
CM CX'PCBXIMAGE and encounters a switch to CM
failure.
ACTION Notify HP Support Representative.
-1002 MESSAGE HPLOADCMPROCEDURE failed on CX'PCBXIMAGE