MPE/iX Error Messages Manual Vol 3 (32650-90880)

218 Chapter5
Error Messages V iii C 4
TermDSM
ACTION Contact your HP support representative.
280 MESSAGE Dump failed. Open of DTCM failed, or DTC
owned and not overridden (TDSM 280)
CAUSE This message is written to dump files, and never appears
as an error message to a user terminal. If the user was
informed the DTC was in use by another TermDSM (see
message 35), and the second user chose NOT to override,
then this message is normal and is not cause for alarm.
Otherwise, it is indicative of an internal error.
ACTION If the problem persists, take another dump. If you are sure
another user was not involved, contact your HP support
representative.
281 MESSAGE Dump failed: Send or Receive of dump request
failed. (TDSM 281)
CAUSE An internal error. This message is written to dump files
and never appears as an error message to a user.
ACTION Contact your HP support representative.
282 MESSAGE Dump failed: Bad function in internal error
reply to dump request.(TDSM 282)
CAUSE An internal error. This message is written to dump files
and never appears as an error message to a user.
ACTION Contact your HP support representative.
283 MESSAGE Dump failed. Bad reply (llio) status from
DTCM. (TDSM 283)
CAUSE Internal error.
ACTION Contact your HP support representative.
290 MESSAGE Sorry, TermDSM does not provide services for
the console. (TDSM 290)
CAUSE The user entered the ldev number of the physical console
for a reset or dump. TermDSM cannot act upon the
physical console port because it is not on the DTC.
TermDSM can only operate on ldev numbers and ports
that are on the DTC. Note: The discussion here is for the
physical console, not a terminal which has taken control of
the logical console via the CONSOLE command.
ACTION Contact your HP support representative.
300 MESSAGE IPC message received in wrong subque. (TDSM
300)
CAUSE Internal error.
ACTION Contact your HP support representative.