MPE/iX Error Messages Manual Vol 3 (32650-90880)
216 Chapter5
Error Messages V iii C 4
TermDSM
ACTION Contact your HP support representative.
261 MESSAGE Bad RMP error code received. (TDSM 261)
CAUSE Unknown error reported by the Distributed Terminal
Subsystem to TermDSM.
ACTION Contact your HP support representative.
262 MESSAGE The DTC subsystem has reported that an error
was detected. (TDSM 262)
CAUSE This is the standard message that precedes specific error
messages.
ACTION Follow the instructions for the error message that follows
this message.
263 MESSAGE An error of unknown type was reported by the
DTS subsystem. (TDSM 263)
CAUSE An error unknown to TermDSM was reported by the
Distributed Terminal Subsystem.
ACTION Contact your HP support representative.
264 MESSAGE The DTC reported an unknown status as a
result of the loopback. Time taken=xx. (TDSM
264)
CAUSE An error unknown to TermDSM was reported by the
Distributed Terminal Subsystem.
ACTION Contact your HP support representative. You can obtain
additional information by running the card selftest
(through the SIC subcommand of the TermDSM RESET
command), the DTC selftest, and the DTC offline
diagnostics.
270 MESSAGE The port is malfunctioning, or not present on
that SIC. Modem SICs have ports zero to five,
and all other SICs have ports zero to seven.
(TDSM 270)
CAUSE The DTC has reported that the port in question is bad or
does not exist.
ACTION Note the range of ports in the error message. If you are
specified a port that does not exist, verify the information
to determine the correct port. For reset and dump, you can
specify an ldev number instead of the port to do the
operation. If the port does exist, a hardware failure has
probably occurred. Contact your HP support
representative. You can obtain additional information by
running the card selftest (through the SIC subcommand of
the TermDSM RESET command), the DTC selftest, and the
DTC offline diagnostics.