MPE/iX Error Messages Manual Vol 3 (32650-90880)

212 Chapter5
Error Messages V iii C 4
TermDSM
234 MESSAGE Console attention. Time = xx msec. (TDSM 234)
CAUSE Probable hardware failure.
ACTION Contact your HP support representative. You can obtain
additional information by running the card selftest
(through the SIC subcommand of the TermDSM RESET
command), the DTC selftest, and the DTC offline
diagnostics.
235 MESSAGE Operation aborted. (TDSM 235)
CAUSE The operation was aborted by the DTC. Possibly, the
download file is invalid.
ACTION Verify the version and integrity of the download file.
Contact your HP support representative. You can obtain
additional information by running the DTC selftest DTC
selftest or the DTC offline diagnostic.
236 MESSAGE End of dump file encountered. (TDSM 236)
CAUSE The end of the DTC upload (dump) file was encountered
when there was still more information to write.
ACTION Verify that there is sufficient disc space (approx. 2200
sectors are required). Otherwise, contact your HP support
representative.
238 MESSAGE Security invalid. (TDSM 238)
CAUSE Internal error.
ACTION Contact your HP support representative.
239 MESSAGE Bad packet. (TDSM 239)
CAUSE Internal error.
ACTION Contact your HP support representative.
240 MESSAGE During a DTC reset/dump request from the
mainframe. (TDSM 240)
CAUSE Informational message which can be printed after an error
message. It describes in which phase of an operation the
error occurred.
ACTION Refer to the cause and action descriptions for the actual
error message preceding message 240.
241 MESSAGE During the DTC download operation. (TDSM 241)
CAUSE Informational message which may be printed after an
error message. It describes in which phase of an operation
the error occurred.
ACTION Refer to the cause and action descriptions for the actual
error message preceding message 241.