MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 5 209
Error Messages V iii C 4
TermDSM
ACTION Contact your HP support representative.
203 MESSAGE Invalid operation. (TDSM 203)
CAUSE Internal error.
ACTION Contact your HP support representative.
204 MESSAGE Request not supported. (TDSM 204)
CAUSE Internal error.
ACTION Contact your HP support representative.
205 MESSAGE Sub request not supported. (TDSM 205)
CAUSE Internal error.
ACTION Contact your HP support representative.
206 MESSAGE Entity not supported. (TDSM 206)
CAUSE Internal error.
ACTION Contact your HP support representative.
207 MESSAGE No such entity. (TDSM 207)
CAUSE Internal error.
ACTION Contact your HP support representative.
208 MESSAGE No parm for entity. (TDSM 208)
CAUSE Internal error.
ACTION Contact your HP support representative.
213 MESSAGE The DTC reported an error or failure. (TDSM
213)
CAUSE Internal error.
ACTION Contact your HP support representative.
218 MESSAGE End of Record received. Time = xx msec. (TDSM
218)
CAUSE Probable hardware failure.
ACTION Contact you HP support representative. You can obtain
additional information by running the card selftest
(through the SIC subcommand of the TermDSM RESET
command), the DTC selftest, and the DTC offline
diagnostics.
219 MESSAGE Too many characters came back. Time = xx
msec. (TDSM 219)
CAUSE More characters were returned than were sent. Someone
might have pressed a key on the terminal under test, if
this was a terminal loopback. Probable hardware failure.