MPE/iX Error Messages Manual Vol 2 (32650-90879)

448 Chapter11
Store/Restore (Native Mode) and TurboSTORE/iX II
(S/R) cont.
ACTION Retype the command and include a '=' sign for SLTDATE
option.
782 MESSAGE EXPECTED 'SLTDATE=date' WHERE date IS A
POSITIVE INTEGER. SYSGEN/STORE INTERFACE
ERROR. (S/R 782)
CAUSE You did not include a valid number for SLTDATE option.
ACTION Check the syntax and include a valid number for
SLTDATE opion.
783 MESSAGE EXPECTED date TO BE WITHIN THE RANGE OF A
POSITIVE INTEGER. SYSGEN/STORE INTERFACE
ERROR. (S/R 783)
CAUSE You did not include a valid number for DATE option.
ACTION Check the syntax and include a valid number for DATE
option.
785 MESSAGE WARNING: 'TIME' OPTION HAS BEEN REDUNDANTLY
SPECIFIED. SYSGEN/STORE INTERFACE ERROR. (S/R
785)
CAUSE The TIME option was entered more than once.
ACTION Information only.
786 MESSAGE 'TIME' OPTION CANNOT BE USED WITH THE
'TRANSPORT' TO MPEv. SYSGEN/STORE INTERFACE
ERROR. (S/R 786)
CAUSE TIME and TRANSPORT options are not allowed on the
same command line.
ACTION TRANSPORT option is invalid when combined SLT/Store
Set is created. Check your syntax and retype the
command.
787 MESSAGE EXPECTED '=time' AFTER 'TIME' OPTION.
SYSGEN/STORE INTERFACE ERROR. (S/R 787)
CAUSE You did not include a '=' sign after the TIME option in your
command line.
ACTION Retype the command and include '=' sign after the TIME
option.
788 MESSAGE EXPECTED 'TIME=time' WHERE time IS A POSITIVE
INTEGER. SYSGEN/STORE INTERFACE ERROR. (S/R
788)
CAUSE You have not entered a valid number for TIME parameter.
ACTION Retype the command and include a valid number for
TIME parameter.
789 MESSAGE EXPECTED time TO BE WITHIN THE RANGE OF A