MPE/iX Error Messages Manual Vol 2 (32650-90879)

412 Chapter10
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
387 MESSAGE 'VOLSET' OPTION CANNOT BE USED WITH THE
'LISTDIR' OPTION. (S/R 387)
CAUSE Volset and listdir options are not allowed on the same
command line.
ACTION Delete either volset or listdir option and retype the
command.
391 MESSAGE 'VOLCLASS' OPTION CANNOT BE USED WITH THE
'VOL' OPTION. (S/R 391)
CAUSE Volclass and vol options are not allowed on the same
command line.
ACTION Delete either volclass or vol option and retype the
command.
392 MESSAGE 'VOLCLASS' OPTION CANNOT BE USED WITH THE
'DEV' OPTION. (S/R 392)
CAUSE Volclass and dev options are not allowed on the same
command line.
ACTION Delete either volclass or dev option and retype the
command.
393 MESSAGE 'VOLCLASS' OPTION HAS BEEN REDUNDANTLY
SPECIFIED. (S/R 393)
CAUSE The VOLCLASS option was entered more than once.
ACTION Information only.
394 MESSAGE EXPECTED '=volumeclassname' AFTER 'VOLCLASS'
OPTION. SYNTAX
'VOLCLASS=volumeclassname' (S/R 394)
CAUSE You did not type the volclass parameter correctly.
ACTION Check the syntax and retype the command.
395 MESSAGE INVALID VOLUMECLASS NAME SPECIFIED FOR
'VOLCLASS' OPTION. VOLUMECLASS NAME MUST
START WITH AN ALPHA "A-Z" AND CONTAIN ONLY
ALPHANUMERIC "A-Z, 0-9", OR "_". SYNTAX
'VOLCLASS=volumeclassname'. (S/R 395)
CAUSE Volumeclass name mispelled or not recognized on the
system.
ACTION Enter a system recognized volumeclass name.
396 MESSAGE VOLUMECLASS NAME SPECIFIED FOR 'VOLCLASS'
OPTION EXCEEDED THE
MAXIMUM ALLOWABLE LENGTH OF 16 CHARACTERS.
SYNTAX