MPE/iX Error Messages Manual Vol 2 (32650-90879)

Chapter 3 105
Volume II Chapter 3
Printer, Tape and Spooler
standard "forms alignment image," if the forms are
positioned correctly on the specified
ldev .
ACTION You are required to enter =REPLY
pin , YES or =REPLY pin
, NO. If the image is correctly positioned, =REPLY, YES and
the requesting program will continue. If the image is not
correctly positioned, reposition the forms and ~~=REPLY,
~~NO''. This will cause the alignment image to be printed
again, and the question will be reissued. For a CIPER
device, the forms alignment image must be printed using
printer controls. It is not automatically printed by
MPE/iX.
6 MESSAGE LDEV
#nnn IN USE, DOWN PENDING
CAUSE You have issued a DOWN command, but the device is in use
by a process.
ACTION As soon as the use count goes to zero, the device will be
down, and you will be notified.
7 MESSAGE LDEV
#nnn NOT READY
CAUSE The specified device is offline or the media is not mounted.
If other action is required such as changing the tape reel,
the program will display messages to that effect.
ACTION Place the device online.
8 MESSAGE LDEV
#nnn OFFLINE
CAUSE You are trying to access a device that is no longer available
to the file system.
ACTION If the device is functional, enter UP
ldev to place device
online.
9 MESSAGE LDEV
#nnn PAPER OUT
CAUSE You ran out of paper on the indicated device.
ACTION Install and align the paper, and place the device online.
10 MESSAGE LDEV
#nnn QUEUE EMPTY NO I/O TO ABORT FOR
DEVICE
nnn
CAUSE You attempted an ABORTIO or =ABORTIO, and no requests
were pending on the device.
ACTION Information only.
11 MESSAGE LDEV
#nnn UNIT FAILURE
CAUSE Bad status was returned from the specified logical device.
ACTION Retry. If the problem persists call your Application
Engineering Organization (AEO).
12 MESSAGE MAX SPOOFLE KILOSECTORS IN USE, ALL QUEUES
SHUT