MPE/iX Error Messages Manual Vol 1 (32650-90878)

132 Chapter2
Command Interpreter
(CIERR)
CHARACTERS LONG. (CIERR 1582)
CAUSE Device class names may not contain more than eight
characters.
ACTION Specify a valid device class name that contains eight or
fewer characters.
1583 MESSAGE LOGICAL DEVICE CLASS "!" CANNOT BE FOUND ON
THE SYSTEM. (CIERR 1583)
CAUSE The logical device class specified is not valid on this
system.
ACTION Specify a valid logical device class.
1584 MESSAGE DS DEVICE MAY NOT BE SPECIFIED. (CIERR 1584)
CAUSE Same as the message.
ACTION Contact your system manager for the correct LDEV
number or device name.
1585 MESSAGE THERE ARE NO DEVICES CONFIGURED IN DEVICE
CLASS "!". (CIWARN 1585)
CAUSE Same as the message.
ACTION Contact your system manager for the correct device class
name.
1590 MESSAGE STREAM FILE MAY NOT BE A SYSTEM DEFINED FILE.
(CIERR 1590)
CAUSE Same as the message.
ACTION Check the syntax and reenter the command.
1591 MESSAGE EXPECTED JUST ONE CHARACTER AS COLON PROMPT
REPLACEMENT. (CIERR 1591)
CAUSE More than one special character was used as a
replacement for the colon prompt.
ACTION Specify only one special character as a replacement for the
colon prompt in the JOB command. By default the system
expects the ! character to be used.
1593 MESSAGE I/O ERROR WHILE READING IN JOB TO BE
STREAMED. (CIERR 1593)
CAUSE Same as the message.
ACTION Check the job file for syntax errors. Make any corrections
(see "JOB" command in the MPE/iX Commands Reference
Manual, and STREAM the file again.
1594 MESSAGE ERROR IN WRITING TO SPOOL FILE. SPOOLING
STOPPED. (CIERR 1594)
CAUSE Same as the message.