MPE/iX Commands Reference Manual (32650-90877)

616 Chapter14
Command List XII
Commands STREAM thru XEQ
Syntax
VSRELEASESYS
volumesetname
Parameters
volume- setname The name of the MPE/iX volume set for which a previously issued
VSRESERVESYS command has been issued. Refer to "Operation Notes."
Operation Notes
This command is used to negate a previously issued VSRESERVESYS command for the
specified volume set. It informs the system that the volume set is no longer reserved
system-wide.
This command does not prohibit individual VSRESERVE (MOUNT) or VSRELEASE (DISMOUNT)
commands issued for the specific volume set by individual users.
The MPE/iX naming convention for volume sets differs from that of MPE V/E for private
volumes. Refer to the MOUNT, DISMOUNT, VSRESERVE, and VSRELEASE commands in this
chapter.
Use
This command may be issued from a session, job, program, or in BREAK. Pressing
Break
has no effect on this command. This command may be issued only from the system console
unless distributed to other users with the ALLOW command.
Example
To request that volume set ACCOUNTING_PAYROLL be released for all users on the system,
enter:
VSRELEASESYS ACCOUNTING_PAYROLL
Related Information
Commands The VSxxxxxx commands in this chapter, DISMOUNT
Manuals Volume Management Reference Manual
VSRESERVE
Notifies the system to keep a particular volume set online. The equivalent compatibility
mode command is MOUNT. (Native Mode)
Syntax
>VSRESERVE [
volumesetname ] [;GEN= genindex ]
Parameters
volume- setname The name of the MPE/iX volume set to be kept online. If you omit the
parameter, the request is issued for the home volume set of the user's
logon group and account. Refer to "Operation Notes."
genindex A value from -1 to 32,767 specifying which generation of the volume set is