MPE/iX Commands Reference Manual (32650-90877)

Chapter 13 577
Command List XI
Commands SHOWLOG thru STORE
An alternate syntax exists for use with the RENAME option:
filestostore [- filestoexclude [-...[= targetname ]
The system stores any file that matches filestostore unless the file also
matches
filestoexclude , which specifies files to be excluded from the
STORE operation. You may specify an unlimited number of
filestoexclude .
Since "-" is a valid character for HFS syntax file names, a blank character
must separate it from HFS file sets to obtain the special negative file set
meaning.
filestostore
filestoexclude
Both filestostore and filestoexclude may be entered in MPE or
HFS syntax. Wildcards are permitted for both MPE and HFS syntax.
The MPE syntax is as follows:
filename [. groupname [. accountname
A lockword may be specified for files to be stored, in the form:
filename/lockword.group.account
The HFS syntax is as follows:
/dir_lev_1/dir_lev_2/.../dir_lev_i/.../filedesig
or
./dir_lev_i/dir_lev_j/.../dir_lev_k/.../filedesig
If the name begins with a dot (.), then it is fully qualified by replacing the
dot with the current working directory (CWD).
Each of the components
dir_lev_i and filedesig can have a maximum
of 255 characters with the full path name being restricted to 1023
characters. Each of the components
dir_lev_i and filedesig can use the
following characters:
Letters a to z
Letters A to Z
Digits 0 to 9
Special characters - _ .
For HFS name syntax, the lowercase letters are treated distinctly from the
uppercase letters (no upshifting). Names in MPE syntax are upshifted.
Both MPE and HFS name components can use the characters @, #, and ?
as wildcard characters. These wildcard characters have the following
meaning:
@ specifies zero or more alphanumeric characters.
# specifies one numeric character.
? specifies one alphanumeric character.