MPE/iX Commands Reference Manual (32650-90877)

464 Chapter12
Command List X
Commands SAVE thru SHUTQ
filename [ /lockword ][. groupname [. acctname ]]
If the file has a lockword, you must specify it; otherwise, the system
prompts you for it. If you do not specify
groupname.acctname , the system
assumes the logon group and account.
HFS Syntax
If the filename begins with a dot (.) or a slash (/), it is parsed according to
HFS syntax.
Operation Notes
• Usage
You can use this command only for permanent disk files you created. Under default
system security provisions, the file must be in your logon account and must belong to
your logon or home group.
• Checking the file status
You can enter the LISTFILE command to determine if a file is currently released or
secured. Refer to the LISTFILE command in this book for more information.
• Access control definition
An access control definition (ACD) overrides file access controls whether or not you have
released or secured the file.
Use
You can enter this command from a session, a job, a program, or in break mode. Pressing
Break does not affect this command.
Example
• To reinstate file access control previously in effect for the file named FILE1, enter:
:SECURE FILE1
Related Information
Commands ALTSECT, LISTF, LISTFILE, RELEASE'
Manuals None
SEGMENTER
Starts the MPE segmenter.
Syntax
SEGMENTER [ listfile ]
Parameters
listfile Actual file designator of an ASCII output file that is to receive listed
output from the MPE segmenter. Formal file designator is SEGLIST.