MPE/iX Commands Reference Manual (32650-90877)
Chapter 9 337
Command List VII
Commands MOUNT thru OUTFENCE
Duplicate name in directory. (CIERR 906)
Related Information
Commands PURGELINK, PURGE, LISTFILE
Manuals None
NEWUSER
Creates a new user.
Syntax
NEWUSER
username
[.
acctname
] [;PASS=[
password
]] [;CAP=[
capabilitylist
]]
[;MAXPRI=[
subqueuename
]] [;LOCATTR=[
localattribute
]]
[;HOME=[
homegroupname
]] [;UID=[
uid
]] [;USERPASS=[{ REQOPT} ][
Expired
]]
The USERPASS parameter is only available if the HP Security Monitor has been installed.
Parameters
username
The name of the user. The name must consist of one to eight alphanumeric
characters, beginning with an alphabetic character.
acctname
The account in which the user is to reside. System manager (SM)
capability is required to use this parameter.
password
User password, used for verifying logon access only. The password must
consist of one to eight alphanumeric characters, beginning with an
alphabetic character. Default is that no password is assigned.
capabilitylist
The list of capabilities, separated by commas, permitted to this user.
Each capability is denoted by a two letter mnemonic, as shown in Table
9-4. on page 338.
Capabilities assigned to the user with the CAP= parameter cannot exceed
those assigned the account. If the account's capabilities are altered, any
capabilities removed from the account are denied to the user. The user's
capabilities are always verified to be a subset of the account's capabilities
at logon. This prevents a user from being granted a capability not assigned
the account. Note that CV capability, which allows users to define
mountable non-system volumes, also gives the user UV capability, so that
they may use mountable, non-system volumes. Default is IA, BA, ND, and
SF.
subqueuename
The name of the highest-priority subqueue that any job or session in the
account can request for executing processes. The
subqueuename
may be
either AS, BS, CS, DS, or ES. The priority specified for the user in NEWUSER
cannot be greater than that specified for the account.
The
subqueuename
defined for the user is checked against the
subqueuename
defined for the user's account at logon. The lower priority of
the two is used as the maximum priority and restricts all processes of the