MPE/iX Commands Reference Manual (32650-90877)

28 Chapter2
Command Structure Defined
Remote Sessions and Command Intrinsics
Remote Sessions and Command Intrinsics
When used to invoke commands on remote systems the COMMAND or HPCICOMMAND
intrinsics do not return a meaningful status code. For more information on calling
intrinsics refer to the MPE/iX Intrinsics Reference Manual.
Running the CI as a Program
The MPE/iX Command Interpreter (CI) is a Native Mode Program. You can run it the way
you would any other program, either by explicitly using the RUN command (the first
example below), or by using the the
implied RUN (the second example):
RUN CI.PUB.SYS
CI
In the first case, the RUN command controls execution of the CI. For more information, refer
to the RUN command in this chapter.
The second case, referred to as
implied run, is limited to recognizing the INFO= and PARM=
parameters. If you enter both INFO= and PARM=, PARM= goes into effect
after the INFO=
string is passed. The Table 2-1. on page 28 shows the Parm= values.
Table 2-1. Parm= values for the CI
Parm Action
0 UDC's are cataloged, the CI banner is displayed, and the WELCOME message is
displayed. This is the default.
1 Same as 0, however the CI terminates after processing the info string; it
terminates after the first command is executed if no info string is specified.
2 UDC's are cataloged, the CI banner is suppressed, and the WELCOME message
is suppressed.
3 Same as 2, however the CI terminates after processing the info string; it
terminates after the first command is executed if no info string is specified.
4 Logon UDC's are executed, UDC's are available, the CI banner is displayed, and
the WELCOME message is displayed.
5 Same as 4, however the CI terminates after processing the info string; it
terminates after the first command is executed if no info string is specified.
-1 UDC's are not cataloged, the CI banner is suppressed, and the WELCOME
message is suppressed. This requires SM capability.
-2 Same as -1, however the CI terminates after processing the info string; it
terminates after the first command is executed if no info string is specified. This
requires SM capability.